Sunday February 25th, 2007|
More Baffle Work
More baffle stuff...I took out a two inch hole saw and cut a hole for the cabin heat inlet. A scat tube will go from this inlet to the cabin heat muff...then one from the heat muff to the cabin air box. You can also see the little screen that's covering this thing. That will get rtv'd into place when I rivet everything together.
And more stuff over here. I cut off the flange on the lower left-hand side and drilled an angle to there. There's a little gap that I'll just fill with red high temp RTV. I also made and installed the angle that runs across this piece as well as the retention tab that holes the forward and aft sidewalls together (you can just see the edge of the tag here...sorry...I forgot to get a good picture of that).
The basic structure of the baffles are done. I started pulling everything apart and cleaning it up. I can hopefully rivet most of this stuff together on Tuesday and then I can start worrying about penetrations for hoses, etc.