Wednesday December 28th, 2005|
More Cabin Frame Work
Today I decided to work a little more on the cabin frame. I started by clecoing on the aft top skins then match-drilling these holes here on the side.
Then I match-drilled the aft holes and countersunk them. yes, I marred these screws up a bit, but these are just temporary. This will all come back out to paint, etc.
Then I used my angle drill to drill these holes on the inside. I tightened everything down so I can take care of the seat interference problem.
Here you can see how the left seat interferes.
And here's the right side. There's about 2/32 more interference on that side. I'll figure this out tomorrow.
You can see that I got my garage up to 72 degrees today. It was about 40 degrees outside today and I got it this warm with just my electric oil-filled space heater. I think I can do much better with the gas heater.